Appendix F Printing with Software
Revision A 9K-L USERS MANUAL Section F - 23
Software interface sample: LOTUS 123 Release 3.1+ for DOS
Before running 123, the Bryce printer must be installed by choosing "GENERIC" "no
backspace" for printer specification.
Run 123
Address should be entered in a single column, all addresses in file must have the same number of
lines (add blank lines if required).
Set the ADDRESS SETUP in the BOS 9K-L menu to equal the number of lines each record. If
page breaks are used, set ADDRESS SETUP in the BOS 9K-L menu to 1 line more than the
number of lines in each record.
Turn AUTO LINE FEED ON in the 9K-L Setup Menu.
Select PRINT
Select PRINTER
Select OPTIONS
Select OTHER
Select UNFORMATTED
Select ADVANCED
Select AUTOLF
Select YES
Select QUIT
Select QUIT
Select GO
P/N 90-00860-001
To Next Page
Loading...
