Bryce 9K-L - Unpacking; The Parts of the Printer

TABLE OF CONTENTS
FOREWORD
INTRODUCTION
UNPACKING Chapter 1
UNPACKING................................................................................................1 - 1
PARTS OF THE PRINTER Chapter 2
THE PARTS OF THE PRINTER..................................................................2 - 1
INPUT BIN........................................................................................2 - 1
CONTROL PANEL & PRINT STATION........................................2 - 1
PAPER CATCH ASSEMBLY ..........................................................2 - 1
ASSEMBLY OF PRINTER COMPONENTS Chapter 3
CHOOSING A GOOD LOCATION FOR THE PRINTER..............3 - 1
REMOVING PROTECTIVE MATERIALS.....................................3 - 1
INSTALLATION OF THE WIRE FORM ASSEMBLY..................3 - 2
INSTALLING THE SLIDING FENCE ............................................3 - 3
CONNECTING THE PRINTER.......................................................3 - 4
CONNECTING THE POWER CORD..............................................3 - 5
OPERATING THE PRINTER Chapter 4
POWER ON...................................................................................................4 - 1
INSTALLING AN INK JET CARTRIDGE......................................4 - 1
REMOVING AN INK JET CARTRIDGE........................................4 - 4
PREPARING THE MEDIA ..............................................................4 - 5
MEDIA TYPES .................................................................................4 - 6
SETTING THE PROPER FEED GAP..............................................4 – 7
SETUP WITH #10 ENVELOPES.....................................................4 - 8
WIRE FORM ADJUSTMENTS........................................................4 - 8
WIRE FORM CENTER ADJUSTMENT .........................................4 - 9
WIRE FORM HEIGHT ADJUSTMENT..........................................4 - 9
FEED RAMP ADJUSTMENT..........................................................4 - 10
SLIDING FENCE ADJUSTMENT...................................................4 - 10
PRINTER TIPS Chapter 5
ADJUSTING THE EXIT ROLLER SLIDER ...................................5 - 1
OUTPUT STACK HEIGHT..............................................................5 - 1
ADJUSTMENT LEVER FINE TUNING .........................................5 - 2
Revision A 9K-L USERS MANUAL Section i - 1
P/N 90-00860-001