Bryce 9K-L - C. Word Length; D. Line Termination

Printer Menu System
• Press the On Line button; now the printer is ready
for use.
C. Word
Length
Use the following steps to change the serial
communications word length.
• Press the Enter button to select this option.
• Press the + or - buttons to scroll through the
options.
a) 7 DATA BITS
b) 8 DATA BITS
• Press the Enter button to select the desired option.
• Press the Menu button several times to back out of
the Setup Menu until the printer displays OFF
LINE.
• Press the On Line button; now the printer is ready
for use.
D. Line
Termination
The typical software line termination is CR = CR; LF
= LF. If your software is not typical then the Line
Termination can be modified.
Use the following steps to change the line termination.
• Press the Enter button to select this option.
• Press the + or - buttons to scroll through the D.
LINE TERMINATION options.
a) (CR = CR; LF= LF)
b) (CR = CR+LF; LF = LF)
c) (CR = CR; LF = CR + LF)
d) (CR = CR + LF; LF = CR + LF)
• Press the Enter button to select the desired option.
• Press the Menu button several times to back out of
the Setup Menu until the printer displays OFF
LINE.
• Press the On Line button; now the printer is ready
for use.
Revision A 9K-L USERS MANUAL Section 6 -
P/N 90-00860-001
26