Manual EVoBASIC v.7 64 / 80
This mode enables you to automatically adjust the level of chlorine in
your swimming pool. Based on the adjusted set value in the "chlorine"
menu, the equipment will stop when it reaches this value, and start-up
again automatically when there is a need for chlorine.
Semi-automatic
Select this mode only if you have a Temperature (NTC/1) probe kit. If
you do not have one, the equipment will not operate correctly in the
semi-automatic mode.
This work mode enables you to determine the daily hours of operation of
the salt water chlorinator based on the volume in m3 of the pool and the
water temperature. Once they have been reached, the chlorinator will
stop although the filtering pump will continue to operate.
Bear in mind that the equipment makes an approximate calculation of
chlorine which it has to produce, based on two known parameters.
However, other factors are not considered, such as the consumption of
chlorine caused by the number of bathers per day.
4.1.4.3- Cleaning
The equipment includes an automatic cleaning system, based on
reversing polarity in the electrolysis cell. These cleaning cycles are
performed regularly. The time between cleaning (in hours) can be
adjusted depending on the water hardness of your swimming pool.
It is possible to select cleaning intervals from 1 to 8 hours.
4.1.4.4 Volume of the swimming pool
Configure the volume of your swimming pool in m3, if the equipment is
to work in semi-automatic mode. The daily chlorination time will be
calculated based on this parameter and the water temperature.
Whenever the value is changed, on exiting the menu the screen will
display the minimum filtering time the pump should work.
To Next Page
Loading...