Quick set-up guide 5
If you need some help, call us on 0800 145 6789* or go to www.bt.com/producthelp
Talk/Standby time
Under ideal conditions, the
handset batteries should give
up to 12 hours talk time or
120 hours standby on a single
charge. (This doesn’t mean you
can unplug the base or leave
the handset for this length of
time without charge).
Please note that new Ni-MH
rechargeable batteries don’t
reach full capacity until
they’ve been in normal use
for several days.
Battery low warning
The
icon will flash, you’ll
see the message
Battery
Low
in the display and hear a
warning beep every minute,
to indicate that you need to
recharge your handset before
you can use it.
You can remove the display
message by selecting Hide. If
the battery charge completely
runs out, the display will show
Batteries
flat.
Please
charge
. You must recharge
the handset batteries before
you can use the handset. If the
charge completely runs out the
handset will switch off. Place
the handset on the base or
charger to charge.
Quick set-up guide 5
2 Activate the batteries and
follow the Set-up wizard
1. Activate the batteries by pulling the plastic tab
away from the back of the handset.
Rechargeable batteries
already fitted
Remove this tab
and charge batteries
for 24 hours before use.
2. The handset will check for a link with the base
station, once found the screen will show
Please
set
the
time
and
date
. The set-up wizard will take you
through the steps for setting the time and date and
adding contacts.
Press the button if you want to follow
the set-up wizard prompt or the
button
to continue to the next prompt until set-up
is complete.
To Next Page
Loading...
Need help?
General
