BT 8600 - Assign VIP Status to a Contact; Change the Access PIN

26 Call control settings
If‘Alldialledcalls’issettoBarred, this will take precedence over the other settings except emergency
numbers 999 and 112 which can still be dialled. If set to Allowed, the status of the other settings will
manage which calls can be made. The default for all Outgoing calls settings is Allowed.
Assign VIP status to a contact
You can assign VIP status to any of your contacts which means when Do not disturb is switched on, these
calls will ring through as normal. The default Do not disturb setting is Allowed. If set to Allowed, calls
from VIPs will ring as normal, if set to Barred, all calls including the VIPs will ring silently, see page 26.
You can also still make calls to VIP contacts when Outgoing Call Control is switched on.
1. In idle mode, press
.
2. Enter the access PIN and select OK. Press
to highlight VIP listandpressSelect.
3. Read the prompt and select Info, read the message and select Yes at the end. Your contacts list will
be displayed.
4. To assign contacts as VIP, highlight the contact and press
.Selectadditionalcontactsifrequiredby
repeating above.
5. Select Options, Add selected will be highlighted, press OK and the selected entries will be added to
your VIP list.
Ifyou’vealreadyaddedcontactstoyourVIP’s,thelistwillbedisplayedwhenyouentertheVIPlistmenu.
You can then select Options to add further VIPs, remove VIPs or assign a VIP ringtone.
Change the access PIN
1. In idle mode, press
.
2. Enter the existing 4 digit remote access PIN. Press
to highlight Change PIN and press Select.
3. Onceyou’vereadtheremindermessage,selectOK then enter the existing 4 digit access PIN and select OK.
4. Enter the new 4 digit access PIN and select OK, then enter it again when prompted and select OK. Access
PIN saved will be displayed.