BT 8600 - Reset handset and base settings

41Using the phone
To change any Base settings
1. Firstly, select Menu, scroll to display Settings and press Select.
Then choose the base setting you want to change from the options below:
Base ringtone melody and volume
Choosefromvebaseringtones.ThedefaultisMelody1.Therearevebaseringervolumelevelsplus
RingerO.ThedefaultisLevel3.
2. Press
to highlight Base settings, press Select.
3. Ringing is highlighted, press Select.
4. Press
or to select the ringtone melody, then press to select the volume level you want and
select Save.
PBX access code
Ifyou’reconnectedtoaswitchboard,youmightneedtoenteranaccesscode(e.g.9)beforeyoudiala
number. Your BT8600 can store an access code which is automatically dialled before each number. We
cannot guarantee that all the BT8600 features will work when connected to a PBX.
2. Press
to highlight Base settings, press Select.
3. Press
to highlight PBX code, press Select. Enter the number you want (maximum four digits).
If you wish to stop using a PBX access code, go into the PBX code menu and delete all the digits by
selecting Clear, then select Save.
Change the system PIN (dierent to the Call control & Remote access PIN)
2. Press
to highlight Change Sys. PIN, press Select.IfthecurrentPINis0000,you’llbeprompted
to enter the new four digit PIN, then press OK.
 IfthecurrentPINisnot0000,you’llbepromptedtoentertheold(current)fourdigitPINrstandthen
select OK. Then follow the prompts and enter the new four digit PIN.
3. Enter the new four digit PIN again and select OK. The display will show New system PIN saved.
Reset the handset or base settings
2. Press
to highlight Reset, press Select.
3. H/set settings is highlighted. Press Select or press
to highlight Base settings and then press Select.