13
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or email bt.helpdesk@vtecheurope.com
When you make a call, the light on
the base ashes.
Call timer
Your handset will automatically time
the duration of all external calls.
The handset display shows the call
duration both during and for a few
seconds after your call.
Out of range warning
When the handset goes out of range
of the base, the
ashes. If you are
on a call, the line will hang up. Move
back within range. The handset will
automatically re-connect to the base.
Using the phone
Switch handset on or off
To switch off
1. Press and hold
for about 5 seconds.
2.
Switch off HS? is displayed, press Yes to conrm.
To switch on
1. Press and hold
until the screen appears.
Making and receiving calls
Make an external call
1. Press .
2. When you hear the dial tone, dial the number.
Preparatory dialling
1. Dial the number rst. If you make a mistake press the left soft
key
Clear to delete the last digit.
2. Press
to dial.
End a call
1. Press .
Receive a call
When you receive a call, the phone rings. The display shows the
caller’s number and if it matches an entry in your phonebook, it
shows the name also. If you do not have a Caller Display service,
the screen shows
External call.
1. Press
.
Earpiece / handsfree volume
During a call you can adjust the volume of the earpiece or
loudspeaker. There are 5 levels.
1. Press
or
to increase or decrease the volume.
Auto answer
As long as you have auto answer set
to ON you can answer a call by lifting
the handset off the base. If you have
switched auto answer off, you will
need to press
as well. Auto answer
ON is the default setting. See page 24.
For more information on Caller Display,
see page 29.
To Next Page
Loading...
