39
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp.com
Default settings
H/S Ringer Volume LEVEL 5
H/S Ringer Melody MELODY 1
B/S Ringer Volume LEVEL 5
B/S Ringer Melody MELODY 1
H/S Earpiece Volume VOLUME 3
H/S Speaker Volume VOLUME 3
H/S Key Beep ON
Auto Answer ON
Handset Name HANDSET
Date/Time 00:00 01/01/10
Base PIN code 0000
Language ENGLISH
Flash time 100ms
Pause time 2-5 seconds
Alarm OFF
Alarm tone MELODY 1
Alarm volume VOLUME 5
Redial List EMPTY
Phonebook memory UNCHANGED
Calls list EMPTY
Answer machine functions
Answer machine ON
Outgoing message ANSWER & RECORD
Outgoing message voice FEMALE
Ring Delay 5 RINGS
Remote access PIN 0000
Call screening ON
Base speaker volume 5
De-register a handset
1. Press
to ADvAnCED sET and press
.
3. Enter the master PIN code (default setting: 0000) and press
.
4. A list of available handset numbers is displayed. Enter the
number of the handset you want to de-register.
5. Press
to cancel. You will hear a long
conrmation beep to indicate de-registration was successful.
Change master PIN
The master PIN is used for handset registration and
de-registration. The PIN is 4 digits long, with a default setting
of 0000.
The answer machine remote access PIN is the same as the master
PIN. If you forget the master PIN you can reset the base to its
default settings and the PIN will return to the default of 0000.
1. Press
to ADvAnCED sET and press
.
3. Enter the current PIN code (default setting: 0000) and press
.
4. Enter the new PIN and press
. If you make a mistake press
to delete a digit and then re-enter it.
5. Enter the new PIN again and press
to conrm.
Reset to default
This resets your BT Graphite 2500 to its default settings.
The redial and calls list will be deleted but the phonebook entries
will remain.
1. Press
to ADvAnCED sET and press .
2. Scroll
. Display shows
COnFIRM?
3. Press
To Next Page
Loading...
