BT STUDIO PLUS 5100 - Handset Charging and Time Format; Handset Charging Procedure

6
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or email bt.helpdesk@vtecheurope.com
Battery low warning
If the
symbol is ashing, you will
need to recharge your handset before
using it.
If the battery icon is ashing and
scrolling digits
the battery is
very low and you will need to charge
it for 24 hours before use to ensure
maximum battery performance.
Battery performance
To keep your batteries in the best
condition, leave the handset off the
base for a few hours at a time (after
the initial 24 hour charge).
New NiMH batteries do not reach
full capacity until they have been in
normal use for several days. Running
the batteries right down at least once
a week will help them last as long
as possible.
IMPORTANT
Only use the power supply and
telephone line cord supplied with
your BT Studio Plus 5100 otherwise
the telephone may not work.
Under no circumstances use
non-rechargeable batteries. Only
use NiMH rechargeable batteries
with a capacity of 500mAh. Using
inappropriate batteries will invalidate
your guarantee and may damage
the telephone.
The charge capacity of rechargeable
batteries will reduce with time as
they wear out, so reducing the
talk/standby time of the handset.
Eventually they will need to be
replaced. New batteries can be
obtained from the BT Studio
Helpline 0800 218 2182*.
3. Place the handset on the base to charge the batteries for
at least 24 hours.
The main handset is pre-registered to the base as Handset 1.
This is shown on the display. When the handset is fully charged
the display shows the
symbol.
4. After 24 hours plug the telephone line cord into the telephone
wall socket.
Note: If you ever need to remove the batteries, simply slide open
the battery compartment cover and using the nger holes grip
the batteries and pull them out.
Set the time format: 24 or 12hr
1. Press the
button to open the main menu.
2. Press
or
until the display shows hS SeTTingS and
press
soft key. DaTe & TiMe is displayed, press the
soft key again.
3.
TiMe FOrMaT is displayed. Press the soft key and the
current format is displayed. Press
or
to change
between 24hr and 12hr. Press the
soft key, you will hear a
conrmation tone.
4. Press the
button to return to standby.