What’s in the box

Powerline adapters x2, ethernet cable, Quick Start guide

Connecting your Powerlines

If your BT Home Hub is in another room or is more than two

metres away from your Vision+ box you’ll need to use your

Powerline adapters

Using the Ethernet cable (yellow ends), connect one end to

your Hub’s Ethernet port 1

Connect the other end to a Powerline adapter

3 Then plug the Powerline adapter directly into a power

socket and turn it on

Using the Ethernet cable provided with your Vision+ box,

connect one end to the LAN socket at the back of your

Vision+ box

Connect the other end to a Powerline adapter

6 Then plug the Powerline adapter directly into a power

socket and turn it on. When you’ve plugged in both your

Powerline adapters, their Data lights should glow green

Note: your Powerline adapters will work with any version

of the BT Home Hub and Vision+ box, not just the ones

shown in the diagram

BT Vision Powerline Adapters

Data

Ethernet

Power

IMPORTANT: to work properly Powerline

adapters must be plugged directly into the

wall socket and not into extension leads

LED status description

Green

Orange

Red

Flashing

Off

Powerline network is detected with high transfer speed

Powerline network is detected with medium transfer speed

Powerline network is detected with low transfer speed

Any of the above ﬂashing – a data transfer in progress

No Powerline connection

Green steady

Green ﬂashing

Ethernet connection is detected

Ethernet trafﬁc is detected

Green steady

Green ﬂashing

Off

Power is on

The unit is in pairing mode, see overleaf

The mains power is off or the unit is in sleep mode.

The unit automatically wakes up from sleep mode when the

device connected to the Ethernet cable is powered up.

BT Vision - Page 14

Table of Contents

Other manuals for BT Vision

Related product manuals