BT Vision - Page 5

Set-up 5
4 Using the other Ethernet cable (yellow ends), connect one end to
the LAN socket at the back of your Vision+ box
™
5 Connect the other end to a Powerline adapter
6 Then plug the Powerline adapter directly into a power socket and
turn it on. When you’ve plugged in both your Powerline adapters,
their Status lights should glow green
Note: only one of your two Powerline adapters will show its
AP/STBY light glowing green – it doesn’t matter which one.
Important: do not turn on your Vision+ box
™
yet.
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
230V ~ 50Hz
25W
USB
LAN
TV
AUX
AUDIO OUT
S-VIDEO
SPDIF
HDMI
RF IN
RF OUT
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
230V ~ 50Hz
25W
USB
LAN
TV
AUX
AUDIO OUT
S-VIDEO
SPDIF
HDMI
RF IN
RF OUT
S
SB
5
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
230V ~ 50Hz
25W
USB
LAN
TV
AUX
AUDIO OUT
S-VIDEO
SPDIF
HDMI
RF IN
RF OUT
S
SB
4
6
IfyourBTHomeHubisinanotherroomorismorethan
twometresawayfromyourVision+box™
You’ll need to use your Powerline adapters.
1 Using one of your Ethernet cables (yellow ends), connect one end
to your Hub’s Ethernet port 1
2 Connect the other end to a Powerline adapter
3 Then plug the Powerline adapter directly into a power socket and
turn it on
Find Handset
Reset to
Defaults
Wireless
Association
Restart
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
Find Handset
Reset to
Defaults
Wireless
Association
Restart
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
2
Find Handset
Reset to
Defaults
Wireless
Association
Restart
STATUS
CONFIG
RESET
ON
STBY
ETHERNET
AP/STBY
1
3
Set-upB