BTECH GMRS-20V2 - Page 51

46
VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
OFF
No lockout
16
SC-ADD
Add Scan
Channel
ON
Add channel to scan list
OFF
Remove channel from scan list
17
SC-REV
Scan Resume
Method
TO
(Time Operation) Scan stops when signal detected. The
scan resumes after approximately 5 seconds (even if
the channel is still active).
CO
(Carrier Operation) Scan stops when signal detected.
Scan resumes when signal disappears.
SE
(Search Operation) Scan stops when signal detected.
Scanning will not resume.
18
OPTSIG
Optional
Signaling
OFF
No optional signaling
DTMF
DTMF signaling selected
2TONE
2TONE signaling selected
5TONE
5TONE signaling selected
19
SPMUTE
Speaker Mute
Settings
QT
Squelch opens for CTCSS/DCS tones only.
AND
Squelch opens when CTCSS/DCS tone is recognized
along with the optional signaling.
OR
Squelch opens when either the CTCSS/DCS tone OR the
optional signaling is recognized.
20
PTT-ID
PTT ID - When
to send
OFF
Do not send
BOT
Send at Beginning of Transmission
EOT
Send at the End of Transmission
BOTH
Send at both Beginning and End
21
PTT-LT
PTT ID -
Transmit Delay
0 > 30
Set Delay Time before transmitting PTT-ID