VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
SKIP!Scanning!Channels!!
You can configure channels to be added or removed from the scanning list on the fly.
1. Press the key to enter the menu.
2. Enter Menu Item 16 on your numeric keypad to come to scanning add mode.
3. Press the key to select.
4. Use the and keys to select if the channel will be added or removed from the scanning
list. On will add the channel to scan, off will remove from the scan list. The change will apply to
the current channel selected
5. Press the key to confirm and save.
6. Press the key to exit the menu.
!
Tone!Scanning!
Scanning for CTCSS and DCS Tones/Codes!
CTCSS tone and DCS code scanning mode can be accessed with or without a signal being present.
The scanning process itself only occurs while a signal is being received.
Not all repeaters requiring a CTCSS tone or DCS code for access will transmit one back. In that
case, the transmitter of a station that can access the repeater would need to be scanned. In
other words: this would be done by listening to stations on the repeater's input frequency.
To Next Page
Loading...
