VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Scanning'for'CTCSS'Tone''
(ACTIVE$SIGNAL$REQUIRED)$
1. Press the key to enter the menu.!
2. Enter on your numeric keypad to come to Menu 11: R-CTCS
3. Press the key to select. Insure you have a tone activated (and it is not off)
4. Press the to begin CTCSS scanning
The CTCSS frequency will change on the screen to indicate the radio is in CTCSS scanning mode. In this
mode, whenever the radio is receiving an RF signal on the selected channel, the display will cycle
through the CTCSS tones as they are being tested. Once the frequency of the received CTCSS tone is
determined, the scan will stop and audio will be able to be heard from the repeater.
Press the key to save the scanned tone into memory, then press the key to exit the menu.
Don't forget to set menu 11 back to OFF when the CTCSS tone is no longer required.
'
'
Scanning'for'a'DCS'tone'
(ACTIVE$SIGNAL$REQUIRED)$
1. Press the key to enter the menu.!
2. Enter on your numeric keypad to come to Menu 10: R-DCS
3. Press the key to select. Insure you have a tone activated (and it is not off)
4. Press the to begin DCS scanning
To Next Page
Loading...
