VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
The DCS code will change on the screen to indicate the radio is in DCS scanning mode. In this mode,
whenever the radio is receiving an RF signal on the selected channel, the display will cycle through the
DCS codes as they are being tested. Once the bits of the received DCS code are determined, the scan will
stop and audio will be heard from the repeater.
Press the key to save the scanned tone into memory then press the key to exit the menu.
Don't forget to set menu 10 back to OFF when the DCS tone is no longer required.
To Next Page
Loading...
