2726
Thermostat with display
Installer manual
6.5 Modification of the set-point using the keypad
Below is a description of how to manually change the temperature set-points.
Press MODE to select the mode for which the
set-point must be changed.
Once the display stops flashing, the new set-
point is saved (the set-point stops flashing and
remains on the display). After this, the display
returns to showing the temperature detected.
The Comfort and Eco set-points can only be modified if the loads have been assigned to
the device, otherwise they are blocked.
The current set-point flashes for a few seconds.
During this time press
+ or – to change the
temperature.
The display flashes for 4 seconds, showing the
new set-point.
To Next Page
Loading...
Need help?
General
