Bticino Sfera Series User Manual

Sfera Display Module
Installer manual
35
4.2 Connection to the PC
To transfer the configuration performed using the TiSferaDesign software, or to update the
firmware, connect the Sfera display Module to the PC using a USB-miniUSB cable.
miniUSB - USB
When updating the software the device must be powered.
The Sfera display Module connected through a USB cable is recognised by the PC as a virtual port
(VIRTUAL COM); the TiSferaDesign software automatically recognises its address.
4 Configuration using the software
4.1 The TiSferaDesign software
All the configurations can be performed using the TiSferaDesign software supplied with the
device
Software configuration is highly recommended as it simplifies and speeds up the whole
procedure. It also gives the possibility of saving on the PC all the configuration data and the
residents address book for later updates or Modifytions.

Bticino Sfera Series Specifications

General

Series	Sfera
Category	Control Unit
Storage Temperature	+70°C
Compatibility	2-wire system
Relative Humidity	95% (non-condensing)
Protection Degree	IP20