Bticino Sfera Series User Manual

Sfera Display Module
Installer manual
7
3 Configuration using the keypad
3.1 Access to the Settings menu
Settings
Configuration
LCD settings
Riser base addr.
Door codes
Address book
Service menu
Exit
Enter
Password
*****
1 Press and hold down the keys for
more than 10 seconds
3 Repeat the procedure at point 2 for the other 4 digits
OK
A
2 Using the keys select the first digit of the
password and confirm using OK
4 If the password is correct, access to the Settings menu is
granted
The password gives the installer access to the settings menu.
The default password is 00000.
We recommend that the default password is replaced with
one of your choice to prevent unwanted access.

Bticino Sfera Series Specifications

General

Series	Sfera
Category	Control Unit
Storage Temperature	+70°C
Compatibility	2-wire system
Relative Humidity	95% (non-condensing)
Protection Degree	IP20