Why is the SMART display blank on my BTSR Control Systems?
If the SMART display is blank, ensure the I/O connector is correctly plugged in and that there's a 24 Vdc power voltage on pins 1-2. Also, check the protection fuses, as the system may be powered off.
What to do if the display shows the ERR COM DXXX screen on btsr SMART 200 TTS Control Systems?
If the display shows the ERR COM DXXX screen on your BTSR Control Systems, the issue might be a faulty or incorrectly numbered sensor. Try assigning a number to the sensor XXX again. If the problem persists, replace the sensor or check the connection cable of the sensor and replace it if necessary. As a final step, try assigning a number to all the sensors again.
Why is the sensors numbering procedure failing on my btsr SMART 200 TTS?
If the sensors numbering procedure fails (the number YYY does not increase in the screen DEV *Y* XXX YYY), verify that the sensors are correctly connected. Also, check for locked sensors (green and red LED simultaneously ON) and power off and on the system. If the problem persists, replace the sensor or connect a set of sensors at a time trying to isolate the problem.
What to do if SMART system does not accept keyboard inputs on BTSR Control Systems?
If the SMART system does not accept keyboard inputs, and the keyboard is not responding on your BTSR Control Systems, the system might have halted due to a sudden over-voltage load. Power off and then on the system. If the problem continues, contact your BTSR reseller.
What does the ERR_OUT DEV XX screen mean on btsr SMART 200 TTS?
If the display shows the ERR_OUT DEV XX screen on your BTSR Control Systems, the Stop output transistor STOP might be shortened. Check the STOP circuit. If the problem persists, replace the sensor.
How to fix a sensor that does not provide the Stop signal on btsr SMART 200 TTS?
If the sensor does not provide the Stop signal on your BTSR Control Systems, there might be a failure in the Stop circuit. Check the Stop circuit connections and the configuration of the Stop signal (ST-NCO). If the problem persists, replace the sensor.
What does ERROR RAM message at startup mean for BTSR Control Systems?
If you see an ERROR RAM message at startup on your BTSR Control Systems, press the button to erase user settings and load default values, then reload your parameters and custom settings. If the problem persists, contact your BTSR reseller. The replacement of the system’s lithium battery may be required.
General| Power Supply | 24 VDC |
|---|---|
| Protection Class | IP20 |
| Communication Interface | RS485 |
| Number of Axes | 1 |
| Output Voltage | 24 VDC |
| Category | Control System |
| Operating Temperature | 0°C to +50°C |
| Storage Temperature | -20°C to +70°C |
| Output Current | 2 A |
To Next Page