6 Operation
This chapter gives examples of typical instrument applications and instructions on how to operate the
instrument properly and safely.
!
Danger
Death or serious poisoning by inhalation or incorporation of dried particles during spray process.
• Wear safety goggles
• Wear safety gloves
• Wear a suitable protective mask
• Wear a laboratory coat
• Check for proper sealing before use
• Do not inhale dried particles
• Stop drying gas flow before opening the drying circuit
!
Warning
Death or serious poisoning by contact or incorporation of harmful substances at use.
• Before operation, check the instrument for correct assembling
• Before operation, inspect sealings and tubes for good condition
• Exchange worn out or defective parts immediately
• Exchange clogged filters immediately
• Only operate the instrument in ventilated environments
• Directly withdraw released gases and gaseous substances by sufficient ventilation
• Perform a dry-run without sample material and check for gas leakages
To Next Page
