6.9 Mini Spray Dryer B-290 acid resistant
For basic operations please see chapters 6.1–6.7.
Nozzle cleaning instructions
1. Clean the nozzle parts immediately after each spray drying run.
2. Wash the nozzle parts with a mild detergent solution.
3. Rinse the parts with hot water and let them dry.
4. Examine the nozzle parts under a microscope to verify that they are clean.
5. Check the integrity of the O-rings. Replace if necessary.
NOTE
Do not use hydrochloric acid (HCl) for cleaning stainless steel.
Do not spray hydrochloric acid (HCl) because it will corrode the stainless steel parts.
To Next Page
Loading...
