Telephone Helpline: 0845 146 2887 (United Kingdom)
5
CC771 OPERATING MODES:
• Standard Mode (M1, M2 & M3 turned off)
• Mode 1 (M1 lit): Extreme mode for very small amount of liquid like blood residue
(10/15cc max.) only to be used 5 times consecutively after which the unit locks down for
10 minutes to cool down (showing the letters ‘EA’ on the display)
• Mode 2 (M2 lit): Extreme Mode + Soft Suction and Manual Anti-crush (press the
‘Welding M1-M2-M3’ button a few moments before reaching the desired vacuum)
• Mode 3 (M3 lit): Standard Mode + Soft Suction and Manual Anti-crush (press the
‘Welding M1-M2-M2’ button a few moments before reaching the desired vacuum)
• Mode 4 (M1-M2-M3 flashing): Dome Function to be used with Dome Accessory (sold
separately)
• Mode 5 (M1-M2-M3 lit): Marinade function to be used with external containers (sold
separately)
TURNING THE MACHINE ON / SETTING THE SEALING TIME
1. Connect the appliance to the mains power supply and switch the machine On [l]
2. Raise the lid until it locks in place – machine is now ready for use in Standard Mode
(M1, M2 & M3 off)
3. Display now shows the default Sealing Time for the Standard Mode
4. If you want to adjust the Sealing Time, simply use the or buttons until the
required units are shown on the display
5. To save any changes made, press and hold the ‘STOP/OK’ button for 2 seconds – the
new value will then flash once
RESET TO DEFAULT SETTINGS
1. Switch the machine Off [O]
2. Simultaneously press and hold the ‘WELDING M1-M2-M3’ and buttons and switch
machine On [I] whilst holding the ‘WELDING M1-M2-M3’ and buttons
3. The letter ‘D’ will be shown on the Display
To Next Page
Loading...
