Buffalo TS3210DN - Shutting down the Terastation Automatically if an Error Occurs

3 Choose a RAID array.
4 Select a RAID mode and the drives to be used, then click Create RAID Array.
5 The “Confirm Operation” screen will open. Enter the confirmation number, then click OK.
6 The process is complete once you close the confirmation window that appears.
When the RAID array has been created, next create a shared folder by referring to the “Adding a Shared Folder”
section in chapter 3.
Shutting Down the TeraStation Automatically If an Error Occurs
This function will shut down the TeraStation automatically if an error occurs on a drive that is used in a redundant
RAID array. To configure auto shutdown, follow the procedure below.
53
Chapter 4 RAID Modes and Drive Management