Your vehicle was originally programmed to Mode 3. The
mode may have been changed since then. To
determine the current mode, or to change the mode, do
the following:
1. Follow the instructions for
Entering Programming
Mode on page 2-47
.
2. Press the LOCK button on the remote keyless entry
transmitter.
3. Count the number of chimes you hear. The number
of chimes indicates the vehicle’s current
programmed mode. If you do not wish to change
the current mode, you can either exit the
programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.
4. Press LOCK on the remote keyless entry transmitter
to change the current mode until you hear the
number of chimes corresponding to the mode
selection you want.
The mode you selected is now set. You can now exit
the programming mode by following the instructions next
in this section.
Exiting Programming Mode
To exit programming mode, do one of the following:
• Press the odometer button, while in odometer mode
for two seconds, or
• turn the ignition key out of ON, or
• do not program any commands for one minute
while in programming mode, or
• shift out of PARK (P). See
Shifting Out of Park (P)
on page 2-28
.
The programming mode message will turn off to let you
know that you are no longer in the programming mode.
2-53
To Next Page
Loading...
Need help?
General
