Removing the Split Bench Seat
Each section of the split bench seat can be flipped
forward or removed individually.
1. Unlatch the shoulder belt from the lap-belt.
2. Make sure that the seatback is in the upright
position.
3. Lift up or push forward on the seatback recliner
lever to fold the seatback forward.
4. For base-level split bench seats, pull the lever at
the base of the seat on the outboard side to
release the rear latches from the floor pins and flip
the seat forward.
For up-level split bench seats, continue pushing
forward on the recliner lever to release the
rear latches from the floor pins and flip the seat
forward.
The seat can stay in this position or it can be
removed from the vehicle by following the
next steps.
Base-Level
1-9
To Next Page
Loading...
