To Next Page

To Previous Page

{CAUTION:

A seat that isn’t locked into place properly can

move around in a collision or sudden stop.

People in the vehicle could be injured. Be sure

to lock the seat into place properly when

installing it.

{CAUTION:

A safety belt that is improperly routed, not

properly attached, or twisted won’t provide the

protection needed in a crash. The person

wearing the belt could be seriously injured.

After installing the seat, always check to be

sure that the safety belts are properly routed

and attached, and are not twisted.

Do not put the stowable seat in so that it faces rearward.

The stowable seat has to go in before the rear

convenience center. See

Rear Convenience Center on

page 2-43

for more information.

The stowable seat has seat position labels, located on

the back of the seat, showing where the seat must go.

The seat must be placed in the proper location for the

legs to attach correctly.

Make sure that the seatback is folded forward before

beginning this procedure.

1. Remove the nuts from the screws.

2. Place the stowable seat on the vehicle ﬂoor so that

the brackets are placed over the screws.

3. Reinstall the nuts back onto the screws. Torque to

approximately 18 lb ft (25 Y).

4. Try to raise the seat to make sure that it is

locked down.

5. Raise the seatback to its upright position.

Push and pull on the seatback to make sure that it

is locked into place.

1-18

Buick Rendezvous 2003 User Manual

Questions and Answers: