BuildClean 512000 - After Using the Air Scrubber

© 2014 ITW Renovation & Remodeling, a Division of Illinois Tool Works Inc.12
After Using the Air Scrubber
Turn the fan off by turning the knob to the OFF
position.
Turn the unit off by moving the Main Power Switch
to the OFF position.
To avoid the migration of dust, remove and bag
the pre-lter after each project. See the section on
Changing the Air Filters for detailed instructions.
Install a clean pre-lter on the unit for the next use.
Inspect the HEPA lter and replace if needed.
See the section on Changing the Air Filters for
detailed instructions.
Thoroughly clean the unit. Wipe down the exterior.
Blow dust out of the opening to the Auto Dust Sensor
using compressed air.