BuildClean 512000 - Operating Instructions; Main Features and Controls

© 2014 ITW Renovation & Remodeling, a Division of Illinois Tool Works Inc.4
Main Features and Controls
Durable Plastic Housing: The BuildClean HEPA
360° Air Scrubber has a durable plastic housing built
especially for the rigors of construction work. It is easy
to clean and resists scufng and denting.
360°Design: Maximizes particle collection, allows
multi-directional air collection and boosts efciency.
Power Status Display: Indicates the status of
the unit - ON, OFF.
Dynamic Fan Speed Control: Improves efciency
as the motor speed automatically adjusts to the lter
load to maintain desired CFM airow.
Hour Meter: Counts and displays the number of
hours the Air Scrubber has been operating, allowing
you to conrm the amount of time the unit has been
used on a job.
Auto Dust Sensor Status Light: When
illuminated, this light indicates that the dust sensor
needs cleaning. See page 8.
Auto Dust Sensor: Allows the Air Scrubber to run in
“AUTO” mode. While in AUTO mode, the Auto Dust
Sensor automatically samples the air and adjusts
the fan speed accordingly. For example, when a high
level of particulate is sensed, the Auto Dust Sensor
will automatically run the Air Scrubber on HIGH until
a lower level of particulate is sensed or the unit is
powered down.
Advanced Two-Stage Filtration System:
1. Pre-Filter - The coarse pre-lter traps larger
particulates.
2. HEPA Filter - High Efciency Particulate Air
(HEPA) lter traps 99.7% of particles down to 0.3
microns in size.
Filter Status Display: Stoplight-style red, yellow and
green LED display indicates the cleanliness of the
pre-lter and HEPA lter.
Filter Status Display
Auto Dust Sensor
Control Knob
Hour Meter
Cover Latch
Pre-Filter
Air Exhaust Vent
Top Cover
Main Power Switch
(located at rear of unit)
Power Status Display
Dust Sensor Status Light