© 2014 ITW Renovation & Remodeling, a Division of Illinois Tool Works Inc.2
Safety Instructions
DO NOT ATTEMPT TO OPERATE THE AIR
SCRUBBER UNTIL YOU READ AND
UNDERSTAND ALL SAFETY PRECAUTIONS AND
MANUAL INSTRUCTIONS.
READ AND SAVE THESE INSTRUCTIONS.
Electrical hazards
1. Damaged cords can be dangerous and should be
replaced immediately.
Risk of electrical shock.
2. Do not connect the air scrubber to an
ungrounded socket.
Risk of electrical shock.
3. Plug unit or rated extension cord into grounded
socket only
4. The Main Power Switch should be turned off
before unplugging the air scrubber.
5. Unplug the air scrubber when carrying out
maintenance work.
Make sure the area of use is rm and level, so that
the air scrubber does not tip over. Risk of personal
injury and damage to unit.
1. Do not stand on unit.
2. Do not sit on unit.
3. Do not drop unit. Falling equipment could cause
personal injury and damage to unit
1. The BuildClean HEPA 360º Air Scrubber can only
be used with dry, non-explosive materials.
2. The machine must not be used in
environments where explosive gases may be
present. Serious risk of explosion.
3. Do not operate in standing water.
4. Keep wiring and motor dry. If electrical
components become wet, allow them to dry
completely before using.
5. Dust that is hazardous to health can be spread
when the pre-lter and the HEPA lter are
replaced. Accordingly, the user should wear
protective glasses, protective gloves, and
breathing protection.
6. Do not puncture the HEPA lter. Risk of dust
dispersion.
The following safety instructions have been included in this manual to provide you with basic information
necessary for safe operation of the BuildClean HEPA 360° Air Scrubber.
WARNINGWARNING
WARNING
WARNING
WARNING
To Next Page
Loading...