How to fix BuildClean 512000 Scrubber that does not start?
If the BuildClean Scrubber doesn't start, ensure it's fully plugged into the outlet. Check that the power switch (red switch at the back) is set to “RESET”. Also, check the GFCI on the back of the unit and depress the “RESET” button. Finally, verify that there is no power failure in the outlet.
What to do if BuildClean Scrubber fan stops suddenly?
If your BuildClean Scrubber fan stops suddenly, first check if there was a power failure and restore power if necessary. If power is not the issue, the unit might be in an “ERROR” state; consult the Error State Table for guidance.
Why are the red filter indicator lights lit on my BuildClean Scrubber?
If the red filter indicator lights are lit on your BuildClean Scrubber, it means the filter is likely blocked or dirty. You should change the appropriate filter.
What to do if BuildClean 512000 fan runs but suction is poor?
If your BuildClean Scrubber fan runs but the suction is poor, start by changing the filters, as they are likely blocked or dirty. If the area is too large for a single unit, add another air scrubber. Also, ensure the unit is close to the dust generation point; if it's too far, move it closer to your work area.
Why does dust or dirty air blow from BuildClean 512000 Scrubber?
If dust or dirty air blows from your BuildClean Scrubber, the filter is likely defective or loose. Try adjusting the filter, or change it if necessary.
How to fix BuildClean Scrubber that rattles during operation?
If your BuildClean Scrubber rattles during operation, check that the cover latches are fastened and tighten the retaining screw.
How to fix Error Code 2 on BuildClean 512000?
To address Error Code 2 on your BuildClean Scrubber: * Install a BuildClean pre-filter. * Ensure the pre-filter activation pin is fully inserted. * Make sure the vent hose isn't blocked.
How to fix Error Code 3 on BuildClean Scrubber?
To resolve Error Code 3 on your BuildClean Scrubber: * Install a BuildClean HEPA filter. * If using a vent hose, ensure it is straight and free from obstructions.
How to fix Error Code 4 on BuildClean 512000 Scrubber?
To fix Error Code 4 on your BuildClean Scrubber, clean the dust sensor by blowing compressed air through the inlet.
How to fix Error Code 1 on BuildClean 512000 Scrubber?
To address Error Code 1 on your BuildClean Scrubber, see the Filter Status Display and change the appropriate filter.
Essential warnings and guidelines for safe operation and handling of the air scrubber.
Instructions for connecting the power cord and turning the unit ON.
Steps to initiate the air cleaning process and select fan speed.
Explanation of available fan speeds (Low, Medium, High, Auto) and their recommended uses.
Lists error codes and their corresponding solutions or causes.
General| Model | BuildClean 512000 |
|---|---|
| Category | Scrubber |
| Power Source | Electric |
| Voltage | 120V |
| Airflow | 500 CFM |
| Filtration | 3-Stage |
| Filter 1 | Pre-Filter |
| Filter 3 | HEPA Filter |
| Filter Efficiency | 99.97% at 0.3 microns |
| Noise Level | 68 dB |
To Next Page