3
SAFETY INSTRUCTIONS
READ CAREFULLY BEFORE ASSEMBLY AND OPERATION OF YOUR SINGLE SIDE BURNER
This single side burner must be installed in accordance with local codes or, if in an area without local
codes, with the latest edition of the National Fuel Gas Code ANSI Z223.1. In Canada, installation must
conform to the standard CAN/ CGA 1-b149.1 and/or .2 (Installation Code for Gas Burning Appliances and
Equipment) and any local codes. Outside the United States, installation must conform with the latest
edition of CE Norms EN498. Parts that are sealed by the manufacturer or agent must not be altered by
the user.
THE LOCATION FOR YOUR SINGLE SIDE BURNER
DO NOT use your single side burner in garages, porches, breezeways, sheds or other enclosed
areas. Your side burner is to be used OUTDOORS ONLY, with at least 21 inches/54 cm/533 mm
clearance from the back and side of any combustible surface. The side burner should not be placed under
or on top of any surface that will burn. Do not obstruct the flow of combustion and ventilation air around the
insert.
PROTECT CHILDREN: Keep children away from the side burner during use and until it has cooled after
you are finished. Do not allow children to operate the side burner.
WARNING! FOR YOUR SAFETY...
- DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
- DO NOT store empty or full spare gas cylinders and/or chemicals under or near this or
any other appliance.
- Keep the fuel hose away from hot surfaces. Protect the fuel hose from dripping grease.
Avoid unnecessary twisting of the hose. Visually inspect the hose prior to each use for cuts,
cracks excessive wear or other damage and replace if necessary.
- NEVER test for gas leaks with a lighted match or open flame.
- NEVER light single side burner with lid closed or before checking to ensure venturi tube is
fully seated inside gas valve orifice.
- NEVER lean over cooking surface while lighting the side burner. Use barbecue tools with
wood handles and good quality insulated oven mitts when operating side burner.
DANGER! IF YOU SMELL GAS...
1. Shutoff gas to the appliance at its source.
2. Extinguish any open flame.
3. Open side burner lid to release any accumulation of fumes.
4. If gas odor persists, immediately contact your gas supplier or your fire department.
CHECKING FOR GAS LEAKS
NEVER TEST FOR GAS LEAKS WHILE THE SINGLE SIDEBURNER IS LIT! Prior to the first use and at the beginning
of each new season (or, if using LP, whenever gas cylinder is changed), it is a must that you check for gas leaks. Follow
these steps:
1) Make a soap solution by mixing one part liquid detergent and one part water.
2) Turn off the heat control valve, and then turn on gas at source.
3) Apply the soap solution to all gas connections: bubbles will appear in the soap solution if connections are not properly
sealed. Tighten or repair as necessary.
4) If you have a gas leak that you cannot repair, turn off the gas at the source, disconnect fuel line from the single side
burner and immediately call your dealer and gas supplier for professional assistance.
To Next Page
Loading...
