EasyManua.ls Logo

BullFrog A7 - Spa Foundation Requirements

Default Icon
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
should be no voids beneath it. Contact your authorized Bullfrog
Spas Dealer before making any leveling adjustments. Structural
damage to the spa resulting from incorrect installation, placement
on an inadequate foundation, or improper leveling will void the
spas warranty.
Elevated Installations: Be certain your deck or elevated
structure can support the maximum lled weight of your spa with
the total weight of occupants that use it. You must know the deck’s
weight-bearing load capacity and ensure that it is greater than the
maximum lled weight of your spa combined with the occupants
using it or serious injury or structural damage could result.
To nd the weight bearing load requirement along with the
maximum lled weight of your spa, refer to the Spa Technical
Specications Chart or contact an authorized Bullfrog Spas Dealer.
Concrete Pad
Concrete Pavers
Pea Gravel or Crushed Rock
CAUTION: Consult a qualied structural engineer or
contractor before the spa is placed on an elevated structure or deck.
Design Considerations
Hard-Surface Options (Decking and Flooring): In
addition to selecting a hard surface that meets the recommended
safety and maintenance criteria, consider textures and colors that
will assist in enhancing the aesthetics of the area in which your
spa will be installed. e decision to match, contrast, or blend the
hard surface colors and textures with those of your spa should
only be made after carefully researching your options. e cost of
a Landscape Architect may be money well spent.
Surrounding Landscape: e correct landscape around
your spa will not only soften the adjacent hard surface areas,
but will add life and much enjoyment to the environment. If
the budget allows, you may want to consult with a Landscape
Architect for expert advice.
Spa-Side Accessories: Besides selecting the correct hard
surfaces and landscape around your spa, the addition of the
proper spa-side accessories will provide just the nishing touch
that you are looking for. Spa steps, benches, towel racks, planter
boxes, or an outdoor replace are just a few of the items that can
be considered when accessorizing your spa.
Delivery Basics
To prepare for the delivery of your spa, make sure the delivery
path is clear and no obstructions are present.
Occasionally a crane is required to install the spa by lifting it to
its nal destination. e crane operator will lift your spa over
walls, buildings, or any other obstruction and place it as close to
the installation site as possible.
Depending on access to the spa site, your spa may be dollied in
either horizontal or vertical position. For your convenience, the
following charts provide the dimensions of your spa in either the
horizontal or vertical position.
WARNING: An empty spa (spa without water in it) must not
be left exposed to sunlight as shell damage may occur. Once the
spa is unwrapped, ll spa with water immediately or shade the spa
with cover or wrapping to prevent direct exposure to sunlight.
WARNING: Watch for power lines.

Other manuals for BullFrog A7

Related product manuals