Bunn ICB - Page 41

Page 41
PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SPRAY OZ/M
This function allows the operator to view or to enter the
actual flow rate coming out of the sprayhead. This is
NOT used to calibrate the actual flow rate, but to tell the
internal controller how fast the water is flowing.
Procedure to adjust the sprayhead flow rate set-
ting:
1. Press and hold the right hidden button until the
display reads SET LANGUAGE. Press the right hid-
den button until the display reads SPRAY OZ/M .
The number represents what the brewer thinks is
the flow rate out of the sprayhead.
2. If the actual flow rate of the sprayhead is known
but is different than the number on the display, use
the (-) and (+) to enter the correct flow rate.
3. When finished, press and release DONE. This saves
the new setting and advances to the next function
screen, BYPASS OZ/M: XX.X. To exit programming
and return to the MAIN SCREEN, press and release
the ON/OFF pad.
P3093
BREW
A
BREW
B
BREW
C
BREW
A
BREW
B
BREW
C
BYPASS OZ/M: XX.X
(-) DONE (+)
SPRAY OZ/M: XX.X
(-) DONE (+)
37077 091704