3 - EN
Installer / Service Manual BURNiT Comfort PM/PM-B
To the attention of:
Authorized installer/service of BURNIT product range
Dear Colleagues,
With our mutual cooperation we build the good reputation of the products and service to the end users.
We rely on your professionalism and timely response. We are ready to assist you on each issue occurred.
Our contact addresses per departments and divisions are available on our website: www.sunsystem.bg
1. Safety Precautions
Pellet stove BURNIT COMFORT is designed in order to give maximum security and ease of use. Still you
should follow the following safety precautions.
1. We recommend to the authorized installer not to leave bare wires not entirely fit into the terminals. To
prevent the contact of bare wires with other parts..
2. The installation process must be performed only by an authorized by the manufacturer installer. Once
the installation is finished the authorized installer is obliged to give to the end user dully filled warranty
card and service card, certifying that the pellet stove is installed according to all the standards applicable
and the installer takes full responsibility for the installation.
3. It is important to obey all the applicable standards in the country where the product is to be installed.
4. The manufacturer bares no responsibility if the above pointed duties are not kept.
5. The instruction manual for use and installation is an integral part of the product. In case it is missing or
lost the end user must notify the installer and/or the manufacturer in order to receive a new copy.
6. This pellet stove should be used only for the purpose for which it was intended.
7. The manufacturer bares no responsibility for damages suffered by people, animals or objects because of
wrong installation or misuse.
8. After removing the packaging material the end user must check up if all the parts/units are available and
if something is missing he should notify the seller in order to receive the missing part.
9. Only original parts must be used for servicing. Contact an authorized service for the products BURNiT.
10. Obligatory maintenance – the pellet stove must be cleaned immediately after each consumption of
certified pellets between 800 kg to 1000 kg or if usage is less at least once a year. This maintenance must
be performed by an authorized by BURNIT service center. As long as the pellet stove is in its warranty
period all the maintenance and service must be performed by the authorized service who has performed
the initial installation.
For safety precautions the following rules must be strictly followed:
The pellet stove must not be operated by children or people with disabilities.
It is forbidden to install the pellet stove in wet or moist spaces such as bathroom, laundry etc. It is
forbidden to touch the pellet stove with wet hands or feet.
It is forbidden to change or not to follow the safety precautions without permission by the authorized
service /installer BURNiT.
The power cable must be protected from damage or disconnection.
Children or people with disabilities are forbidden to access unattended the room where the pellet stove
is installed.
The door of the pellet stove must be closed when the product is in working mode.
You must avoid direct contact with the hot surfaces of the pellet stove.
Check for difficulties when starting the pellet stove before the start of the heating season or in cases
when the product has not been used for a long time (see chapter 6.0).
The pellet stove is designed to work even in extreme weather. Still in case of strong wind or very chill
weather the safety system of the product may automatically turn of the pellet stove. In that case the
To Next Page
Loading...