GB
112
Fault Elimination
The situations listed below refer only to the direct mode of operation of the Presence
Detector. Please refer to the appurtenant Operating Instructions of the FM Inserts and/or the
IR Hand-held Transmitter 6010 for further information regarding the elimination of faults.
Diagnosis Cause/Remedy
Load-relay does not - Defective load-relay, replace
generally switch: - Replace upstream fuse/switch on again
- Repair broken supply lead
- Check connections on the FM Insert
- Replace device if necessary
Presence Detector - Check potentiometer settings
does not react: - Clean soiled lens
- Increase too low brightness limit value
To Next Page
Loading...