BUSCH MV 1202 B - Connecting Lines; Pipes; Suction Connection; Discharge Connection

Installation | 5
Instruction Manual_MINK MV 1202 B_EN_en 11 | 32
5.2 Connecting Lines / Pipes
WARNING
Rotating Parts.
Risk of severe injury!
● Do not operate the machine without suction / discharge connection installed.
● Remove all protective covers before installation.
● Make sure that the connection lines cause no stress on the connections of the machine. There-
fore, we recommend installing flexible joints on the suction and discharge connections.
● Make sure that the line size of the connection lines over the entire length is at least as large as
the connections of the machine.
In case of long connection lines, it is advisable to use larger line sizes in order to avoid a loss of effi-
ciency. Seek advice from your Busch representative.
5.2.1 Suction Connection
NOTICE
Ingress of foreign objects or liquids.
Risk of damage to the machine!
If the inlet gas contains dust or other foreign solid particles:
● Install a suitable filter (5micron or less) upstream from the machine.
Connection size(s):
– DN100 PN10/16
Depending on the specific configuration ordered, other connection dimensions may apply.
● Make sure that the connection lines cause no stress on the connections of the machine. There-
fore, we recommend installing flexible joints on the suction and discharge connections.
5.2.2 Discharge Connection
NOTICE
Discharge gas flow obstructed.
Risk of damage to the machine!
● Make sure that the discharged gas will flow without obstruction. Do not shut off or throttle the
discharge line or use it as a pressurized air source.
Connection size(s):
– DN100 PN10/16
Depending on the specific configuration ordered, other connection dimensions may apply.