7 | Commissioning
16 | 32 Instruction Manual_MINK MV 1202 B_EN_en
7 Commissioning
NOTICE
The machine is shipped without oil.
Operation without oil will damage the machine in short time!
● Prior to commissioning, the machine must be filled with oil, see Filling Oil [➔12].
NOTICE
Lubricating a dry running machine (compression chamber).
Risk of damage to the machine!
● Do not lubricate the compression chamber of the machine with oil or grease.
CAUTION
During operation the surface of the machine may reach temperatures of more than 70°C.
Risk of burns!
● Avoid contact with the machine during and directly after operation.
CAUTION
Noise of running machine.
Risk of damage to hearing!
If people are present in the vicinity of a machine that is not insulated from noise for extended peri-
ods of time:
● Make sure to wear hearing protection.
● Make sure that the Installation Conditions [➔10] are met.
● Make sure that the operating conditions comply with the Technical Data [➔26].
As soon as the machine is operated under normal operating conditions:
● Measure the motor current and record it as reference for future maintenance and trouble-
shooting work.
7.1 Conveying Condensable Vapors
Use the machine in Aqua version for conveying water vapor or other condensable vapors. The ma-
chine in Aqua version is able to convey up to 100% saturated water vapor.
The conveyance of other vapors than water vapor shall be agreed upon with Busch.
● Make sure that any condensate from the suction side will not enter the non-operating machine.
Before process:
● Warm up the machine by running the machine for 30 minutes.
After process:
● During process condensate may occur in the machine. To remove the condensate from the
machine, convey dry air at 400 mbar with the machine’s maximum speed for 30 minutes, after
the process and at least once a day.
To Next Page
Loading...
