11
SPECIFICATIONS
Power Supply Adaptor: 100-240V AC to 8V DC
Battery: 6 x 1.5V AA
Power consumption: 5 Watts
RF section: Band III 174 ~ 240Mhz
Input: 50R, nominal
Sensitivity: -95dBm typical
FM frequency: FM (87.5-108MHz)
Headphone Output: 3.5mm stereo jack socket
In the unlikely event of difculties with your appliance please follow the trouble shooting guide
below. If the problem persists, contact the retailer if the machine is still under guarantee.
Customer helpline: 0870 600 3030
PROBLEM CAUSE SOLUTION
No Sound
Static Sound
Sound is
distorted
Volume not turned up
Signal reception too low.
Volume is too high.
Adjust the main volume knob.
Adjust the antenna or move the
unit to a stronger signal location.
Desired station not found Weak signal Use the Manual Tune function.
The display shows
“SERVICES N/A”
No DAB coverage in your
area.
Poor reception Adjust the position of the aerial.
The display is blank This may occur if the
broadcaster changes the
label of a service or removes
a label while tuned.
the radio will try to retune.
perform a scan.
I can hear a burbling
noise on some stations.
Battery power is low
Weak signal
Insert some new batteries
Use mains power
try re-positioning the aerial
TROUBLESHOOTING SPECIFICATION
To Next Page
Loading...
