8
DAB OPERATION DAB OPERATION
1. 1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Full Scan> option appears press either or and nd
<Manual Tune>.
3. Use the / buttons to cycle through the DAB channels, which are numbered
from 5A to 13F.
4. Now press the ENTER button to enter the current ensemble/multiplex, the top line
will now display the rst station in the ensemble/multiplex.
5. To see what stations are present in the found ensemble/multiplex, just press either
or buttons. When you’ve located a station that you would like to listen to, just
press the ENTER button
6. Once you have reached the last station in the found ensemble, it will revert back
to the rst station again. If you wish to exit the manual tuning mode, just press the
ENTER button.
10 Pruning
When the radio has performed a Scan in several locations you may nd there are
stored stations that you can no longer receive. This function automatically removes
them from the stored station list.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Full Scan> option appears press either or and nd <Prune>, press
the ENTER button.
3. Use the or buttons to select YES or NO and press ENTER to select.
11 DRC ( Dynamic Range Control )
The causes the radio to reduce the dynamic range of the audio signal. The purpose
of this is to adapt the dynamic range of the audio signal to listening in a noisy
environment.
NOTE: this is not available on many DAB stations.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Full Scan> option appears press either or and nd <DRC>, press
the ENTER button.
3. Choose between DRC off, DRC Low and DRC High.
4. Press ENTER to save the setting.
1 Switching from DAB to FM
Press the DAB/FM button once to switch. The display will show FM Mode.
Once activated the radio will automatically tune to the nearest available station.
To Next Page
Loading...
