Bush CSPK200 - Remote Control Preparation; Installing Remote Batteries; Remote Control Range and Use

Getting to know your Party Speaker
You’ll be up and running in no time
Getting to know your Party Speaker
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting
Preparing the remote control
1. Before use remove the plastic tab insterted into the battery
compartment on the rear of the remote control. (Fig 1). Once
remove the remote will be functional.
Installing batteries in the remote control
As the battery becomes exhausted the operating distance
will shorten. When the remote no longer operates the unit,
replace the battery with a new CR2025 lithium battery.
• Dispose of used batteries with regard to the recycling
regulations in your area.
• Do NOT short circuit batteries or throw them into water,
the general rubbish or in a fire. Weak batteries can leak and damage the remote
control. Replace them in good time!
• Keep coin-sized button batteries out of sight and out of the reach of children. Coin
lithium batteries can cause serious injury when swallowed.
Dispose of used batteries with regards to the recycling regulations in your area. Do
NOT short circuit batteries or throw them into water, the general rubbish or in a fire.
Weak batteries can leak and damage the remote control. Replace them in good time.
Remote control range
1. When using the remote control always point the top end towards the
IR sensor on the front of the party speaker.
2. Ensure you are within approx 8M range and there are no objects
covering the IR sensor on the front of the party speaker.
3. If the remote usage becomes intermittant or the operating distance is
shortened, replace the CR2025 battery as outlined above.
Fig 1.
UNPAIR
MODE