Bush DAB820 - NFC Touch Point

Getting to know your All in One Micro HiFi
You’ll be up and running in no time
Getting to know your All in One Micro HiFi
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hoot ing
NFC touch point
Your Micro has an NFC touch point to enable quick and easy Bluetooth pairing with other
NFC enabled devices.
In Bluetooth (BT) Mode:
1. When ‘Disconnected’ is displayed, just touch your other NFC enabled device to
the NFC touch point logo on the top of your Micro. When pairing is complete
‘Connected’ will be displayed.
Note: The Bluetooth name of your Micro is ‘BUSH ALL IN ONE’.
2. To disconnect an NFC bluetooth connection, just touch your other NFC enabled
device to the NFC touch point logo again. After disconnection, ‘Disconnected’ will be
displayed again.
Connect to a Bluetooth device
Check that your Micro is in Bluetooth (BT) mode. If you are not already in BT mode, press
and release the Mode button until you are in BT mode (check the display). ‘Disconnected’
will be displayed, whilst your product searches for Bluetooth devices.
In Bluetooth (BT) Mode:
1. ‘Disconnected’ will be displayed whilst your product searches for Bluetooth devices.
2. On the device that you would like to connect to your Micro via Bluetooth (e.g. iPhone/
iPad/Android/other phone/Tablet/Computer), turn on Bluetooth connectivity and
ensure that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.