• Day and date - supplied by the broadcaster.
1. Repeatedly press and release the Info. button to cycle through the different
information options.
CD Mode
Check that your Micro is in CD mode. If you are not already in CD mode, briefly press and
release the Mode button until you are in CD mode (check the display). The display will
show ‘Reading’, followed by ‘No disc’, if the CD compartment is empty.
Play a CD
Note: It is not possible to play DVD or computer CDs.
1. Press and release the Eject button. The CD drawer will open and ‘Open’ will be
displayed.
2. Place an audio CD, label side up, onto the CD tray. Please ensure that the CD is laying
flat within the recessed CD shaped area on the tray.
3. Press and release the Eject button. The CD drawer will close. ‘Reading’ will be
displayed and after a short delay, ’Stop’ together with the number of tracks and total
number of minutes and seconds on the CD.
CD controls
You can use the following controls on your Micro in CD mode.
• Play
Press and release the button. After a short delay the first track will begin to play
and the track number and the elapsed time of the track will be displayed.
• Pause
Press and release the button. The elapsed time of the track will flash in pause
mode. Press and release the button again to continue to play the track/CD.