Safety information8
Safety information
Important - Please read these instructions fully before
installing or operating
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hootin g
Power source
• Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
• Disconnect your Micro from the mains power supply during thunderstorms.
• Always check that you have completely switched off your Micro System, before you
change or disconnect the power supply.
• Where the mains power plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• If the Micro System will not be used for a long period of time, remove the CD and
make sure that the mains power is unplugged.
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
Heat sources and flames
• Do not leave it in high temperatures as electronic devices and plastic parts may warp
in heat.
Ventilation
• Do not block or cover slots, holes or openings on the product by placing on soft
furnishings such as carpets, rugs or beds as these are provided for functionality and/or
ventilation to ensure safe operation of the product.
• The underneath and sides of this product may become warm after a long period of
use. This is normal.
To Next Page
Loading...
