Bush DAB820 - Audio Mode; Storing an FM Station Preset

Using your All in One Micro HiFi
Let’s get started
Using your All in One Micro Hi-Fi
28
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hoot ing
Audio mode
The radio will automatically switch between Stereo and Mono, depending on the quality
of the signal being received but you can override this function and manually switch
between ‘Stereo’ and ‘Mono’.
Note: You may wish to select ‘Stereo’ if you are listening to your Micro using
headphones.
1. Press and release the Menu button. Use the left hand rotary control to scroll to Audio
setting. Press the left hand rotary control to Select.
There are now two different options of ‘Forced mono’ and ‘Stereo allowed’ and the
current setting will have a tick next to it.
2. Use the left hand rotary control to move to and choose from the two options
available. Press the left hand rotary control to confirm.
3. Press and release the Menu button to exit from the Menu.
Storing an FM station preset
Your Micro can store up to 10 FM radio stations in its preset memories for instant access to
your favourite stations.
1. Tune the Micro to the FM radio station that you wish to preset.
2. Press and hold the Preset button for approximately 2 seconds until ‘Save to Preset’ is
displayed.
3. Use the left hand rotary control to scroll to the preset location that you would like to
store the radio station to (1-10).
4. Press the left hand rotary control to Select. The display will confirm ‘Preset X saved’,
where ‘X’ is the number of the preset (1-10).
Note: If there is already an existing FM station stored under a preset, it will be over
written when you store the new station.