Bush DAB820 - FM Radio Mode

Using your All in One Micro HiFi
Let’s get started
Using your All in One Micro Hi-Fi
26
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hoot ing
There are 3 levels of compression:
• DRC off: No compression. This is the default setting.
• DRC low: Medium compression.
• DRC high: Maximum compression.
1. Press and release the Menu button. Use the left hand rotary control to scroll to DRC.
2. Press the left hand rotary control to Select. The current DRC setting will have a tick
next to it.
3. Use the left hand rotary control to move through the options and press the left hand
rotary control to confirm.
4. Press and release the Menu button to exit from the Menu
FM Radio mode
Check that your Micro is in FM radio mode. If you are not already in FM mode, briefly
press and release the Mode button until you are in FM mode (check the display). When
your Micro is in FM mode it can receive Radio Data System or ‘RDS’ information if this
is being transmitted by the broadcaster. RDS information will often include the station
name, detail about the programme and the current time.
If you were listening to an FM station when you switched the Micro off then this station
will be automatically selected when you switch the Micro back on.
Telescopic radio aerial
Please make sure that the telescopic aerial on the back of the Micro is fully extended
and adjusted before you attempt to tune to an FM radio station (a vertical position is
recommended). This will ensure that the maximum signal strength is available when the
Micro begins to scan. Extending the aerial also ensures the best possible sound quality.