22
Using your All-in-one System
Let’s get started
Time:
Rotate the dial button to choose “Set Time/Date” – “Auto update” – “Set 12/24 hour”- “Set date
format”, press the “Enter” button to into each setting.
Set Time/Date manually:
Press the “Enter” button, now the “date digit” will flash, rotate the dial button to choose correct
date and press the “Enter” button” button to confirm.
Then the “month digit” will flash, rotate the dial button to choose correct month and press the
“Enter” button to confirm.
Then the “year digit” will flash, rotate the dial button to choose correct year and press the “Enter”
button to confirm.
Then the “hour digit” will flash, rotate the dial button to choose correct hour and press the “Enter”
button to confirm.
Then the “minute digit” will flash, rotate the dial button to choose correct minute and press the
“Enter” button to confirm. Now time and date have been set and was saved.
Auto update: choose “update from any” – “update from DAB”- “update from FM” – “No update”,
press the “Enter” button to confirm.
Set 12/24 hour: rotate the dial button to choose set 24 hour or set 12 hour, press the “Enter”
button to confirm.
Set date format: rotate the dial button to choose DD-MM-YYYY or MM-DD-YYYY, Press the “Enter”
button to confirm.
Backlight:
You can configure the display lighting under BACKLIGHT:
– Dim the display in standby mode after a pre-determined time
– Display brightness
Setting the dim time, Choose Timeout: “on” – “10 sec” – “20 sec” – “30 sec” – “45 sec” – “60 sec”
– “90 sec” – “120 sec” – “180 sec”, press the “Enter” button to confirm.
Display brightness during operation
Select On level and choose “High” – “Medium” – “Low”, press the “Enter” button to confirm.
Display brightness in standby mode
Select DIM level and choose “High” – “Medium” – “Low”, press the “Enter” button to confirm.
To Next Page
Loading...
