Attention !/ Perhatian !
1. When operating the machine, please pay attention
to the position of the needle and do not touch it with
your hands。
Any moving parts, such as needles and handwheels, that could
otherwise cause injury.
2.When sewing, do not pull the cloth too hard, otherwise it
will lead to bending or broken needle.
3. Do not adjust the pattern wheel while sewing.
1. Saat mengoperasikan mesin, harap perhatikan posisi jarum
dan jangan menyentuhnya dengan tangan Anda。
Setiap bagian yang bergerak, seperti jarum dan roda tangan,
yang dapat menyebabkan cedera.
2. Saat menjahit, jangan menarik kain terlalu keras, karena akan
menyebabkan jarum bengkok atau patah
3. Jangan menyetel roda pola saat menjahit.
1.
Select the pattern to be sewn. (See instructions on page P7)
2.
Adjust the thread tension according to the tension of
the stitches
after sewing. (See instructions on page
P15)
3.
Place the fabric under the presser foot, then turn
the handwheel counterclockwise to place the needle
at the start of sewing.
4.
Move the lower presser foot lever and lower the presser foot, you
can sew a few stitches by hand first to check whether
there is any error such as threading. When there is no
error, the sewing machine can be powered on.
5.
Press the power switch to "1" (on) side to energize the
machine，and set the speed adjustment switch to "SLOW"
(SLOW) to start sewing. If
use foot switch; Turn the speed
control switch to "OFF" (OFF), step on it with
your foot, and
the machine can sew.
6.
By holding the fabric with your hand, you can correct the
sewing direction of
the fabric. If it is a corner, you can first adjust
the speed adjustment switch
to "STOP" then turn the fabric to the angle you need, and then
adjust the speed adjustment switch to "SLOW" (slow speed),
and then sew (See
instructions on page P16).
7.
If you finish sewing, you just need to turn the speed
adjustment switch to "STOP" and the machine will stop
sewing.Or when you use the foot pedal, just lift your foot and
stop pressing the foot switch, and the machine will
stop
sewing.
8.
When finished sewing, you can pull out the top and bottom
threads,and
cut the threads with the thread cutter at the
front of the machine. (As shown on the right)
1. Pilih pola yang akan dijahit. (Lihat petunjuk di halaman
NP7)
2. Sesuaikan ketegangan benang sesuai dengan
ketegangan jahitan setelah menjahit. (Lihat petunjuk di
halaman P15)
3. Letakkan kain di bawah sepatu penindas, lalu putar roda
tangan berlawanan arah jarum jam untuk menempatkan
jarum di awal menjahit.
To Next Page
Loading...
