When sewing serrated patterns, the upper thread tension is usually lower than the tension of
straight sewing, and the sewing effect is better.
Saat menjahit pola bergerigi, tegangan benang atas biasanya lebih rendah daripada tegangan
jahitan lurus, dan efek menjahitnya lebih baik
The sewing machine purchased has been equipped
with HAX1.14 needle.
The smaller the line number, the thicker the line;
The larger the needle number, the thicker the needle.
When sewing, first perform trial sewing by manually
Turning the handwheel,and observe Needle punching
effect and conveying condition, and then machine sewing.
If the fabric, thread, and needle are not selected
correctly,the needle may bend or break; in addition, the
stitching may be uneven or skip stitches.
Presser foot
1
hen the stitch reaches the cloth corner, please STOP the sewing machine, turn the speed adjustment
switch to "STOP",keep the needle in the next needle position (needle in the cloth).
Raise the presser foot lever, then turn the fabric (turn the fabric with the needle as the center axis)
to the proper position as required.
Lower the presser foot lever, then start sewing, set the speed switch to "SLOW" and continue sewing.
15. Selection of thread and needle/ Pemilihan benang dan jarum
Mesin jahit yang dibeli telah dilengkapi dengan jarum HAX1.14.
Semakin kecil nomor baris, semakin tebal garisnya;
Semakin besar nomor jarum, semakin tebal jarumnya.
Saat menjahit, pertama-tama lakukan penjahitan percobaan
dengan memutar handwheel secara manual, dan amati peninjuan
Jarum efek dan menyampaikan kondisi, dan kemudian mesin
jahit.
Jika kain, benang, dan jarum tidak dipilih dengan benar, jarum
bisa bengkok atau patah; selain itu, jahitannya mungkin tidak rata
atau jahitannya terlewati.
16.Change sewing direction/Ubah arah menjahit
To Next Page
Loading...