GasAlertMicroClip
Quick Reference Guide
Maintenance
To keep the detector in good operating condition, perform
the following basic maintenance as required:
• Calibrate, bump check, and inspect the detector at
regular intervals.
• Keep an operations log of all maintenance, bump
checks, calibrations, and alarm events.
• Clean the exterior with a soft damp cloth. Do not use
solvents, soaps, or polishes.
Replacing a Sensor or Sensor Filter
a Warning
To avoid personal injury, use only sensors specifically
designed for the detector.
To replace a sensor or sensor filter, refer to the following figure,
table, and set of instructions.
12
To Next Page
Loading...
